User manual

77
4.10.2.15 P2P
The P2P interface is shown as in Figure 4-80.
You can use you cell phone to scan the QR to add the device via the client on the cell phone. For
detailed information, refer to the P2P operation manual included in the resources CD.
Figure4‐80
4.10.3 Event
4.10.3.1 Detect
In the main menu, from Setting->Event->Detect, you can see motion detect interface. See
Figure 4-81.There is three detection types: motion detection, video loss, tampering.
 The video loss has no detection region and sensitivity setup and tampering has no
detection region setup.
 You can see motion detect icon if current channel has enabled motion detect alarm.
 You can drag you mouse to set motion detect region. Click OK button to save current
region setup. Right click mouse to exit current interface.
 For digital channel, the detect function refers to support detection function of the front-
end and support local activation function. The front-end can get enable/disable status,
sensitivity and region setup. You can get corresponding prompt if front-end can not get
the above information. You can change front-end setup if it can get.
4.10.3.1.1 Motion Detect
After analysis video, system can generate a video loss alarm when the detected moving signal
reached the sensitivity you set here.
Detection menu is shown as below. See Figure 4-81.
 Event type: From the dropdown list you can select motion detection type.
 Channel: Select a channel from the dropdown list to set motion detect function.
 Enable: Check the box here to enable motion detect function.
 Region: Click select button, the interface is shown as in Figure 4-82. Here you can set
motion detection zone. There are four zones for you to set. Select a zone first and then left
drag the mouse to select a zone. The corresponding color zone displays different detection
zone. You can click Fn button to switch between the arm mode and disarm mode. In arm
mode, you can click the direction buttons to move the green rectangle to set the motion