User manual

Figure4‐76

Enable the SNMP function. Use the corresponding software tool (MIB Builder and MG-SOFT MIB

Browser. You still need two MIB file: BASE-SNMP-MIB, DVR-SNMP-MIB) to connect to the

device. You can get the device corresponding configuration information after successfully

connection. Follow the steps listed below to configure.

 In Figure 4-76, check the box to enable the SNMP function. Input the IP address of the PC

than is running the software in the Trap address. You can use default setup for the rest items.

 Compile the above mentioned two MIB file via the software MIB Builder.

 Run MG-SOFT MIB Browser to load the file from the previous step to the software.

 Input the device IP you want to manage in the MG-SOFT MIB Browser. Set the

corresponding version for your future reference.

 Open the tree list on the MG-SOFT MIB Browser; you can get the device configuration. Here

you see, how many video/audio channels, application version, etc. the device has.

Port conflict occurs when SNMP port and Trap port are the same.

4.10.2.12 Multicast : Multicast setup interface is shown as in Figure 4-77.

Figure4‐77