User manual
70
Figure4‐69
4.10.2.8 Email
The email interface is shown as below. See Figure 4-70.
SMTP server: Input your email SMTP server IP here.
Port: Input corresponding port value here.
User name: Input the user name to login the sender email box.
Password: Input the corresponding password here.
Sender: Input sender email box here.
Title: Input email subject here. System support English character and Arabic number. Max
32-digit.
Receiver: Input receiver email address here. System max supports 3 email boxes. System
automatically filters same addresses if you input one receiver repeatedly.
SSL enable: System supports SSL encryption box.
Interval: The send interval ranges from 0 to 3600 seconds. 0 means there is no interval.
Health email enable: Check the box here to enable this function. This function allows the
system to send out the test email to check the connection is OK or not.
Interval: Check the above box to enable this function and then set the corresponding interval.
System can send out the email regularly as you set here. Click the Test button, you can see
the corresponding dialogue box to see the email connection is OK or not.
Note system will not send out the email immediately when the alarm occurs. When the alarm,
motion detection or the abnormity event activates the email, system sends out the email
according to the interval you specified here. This function is very useful when there are too many
emails activated by the abnormity events, which may result in heavy load for the email server.
Figure4‐70