User manual

154
For the ATM/POS without the protocol, the interface is shown as in Figure 5-76.
Source IP refers to host IP address that sends out information (usually it is the device host.)
Destination IP refers to other systems that receive information.
Usually you do not need to set source port and target port.
There are total four groups IP. The record channel applies to one group (optional) only.
Six frame ID groups verification can guarantee information validity and legal.
Figure5‐76
5.8.5.5 Account
Note:
 For the character in the following user name or the user group name, system max supports
6-digits. The space in the front or at the end of the string is null. The valid string includes:
character, number, and underline.
 The user amount default setup is 64 and the group amount default setup is 20. The factory
default setup includes two levels: user and admin. You can set the corresponding group and
then set the rights for the respective user in the specified groups.
 User management adopts group/user modes. The user name and the group name shall be
unique. One user shall be included in only one group.
5.8.5.5.1 User name
In this interface you can add/remove user and modify user name. See Figure 5-77.
Figure5‐77