User manual
142
Parameter Function
Show message System can pop up a message to alarm you in the local host screen if you
enabled this function.
Buzzer Check the box here to enable this function. The buzzer beeps when an
alarm occurs.
Alarm upload System can upload the alarm signal to the centre (Including alarm centre.
Message When 3G network connection is OK, system can send out a message
when motion detect occurs.
Send Email If you enabled this function, System can send out an email to alert you
when an alarm occurs.
Tour You need to check the box here to enable this function. System begins 1-
wiindow or multiple-window tour display among the channel(s) you set to
record when an alarm occurs.
PTZ Activation Here you can set PTZ movement when alarm occurs. Such as go to preset
X. See Figure 5-54.
5.8.3.1.2 Video Loss
The video loss interface is shown as in Figure 5-55.
After analysis video, system can generate a video loss alarm when the detected moving signal
reached the sensitivity you set here.
Note video loss does not support anti-dither, sensitivity, region setup. For rest setups, refer to
chapter
5.8.3.1.1 Motion detect for detailed information.
Figure5‐55
5.8.3.1.3 Tampering
The tampering interface is shown as in Figure 5-56.
After analysis video, system can generate a tampering alarm when the detected moving signal
reached the sensitivity you set here.
For detailed setups, refer to chapter 5.8.3.1.1 motion detect for detailed information.