User manual

141
Figure5‐54
Refer to the following sheet for detailed information.
Parameter Function
Enable You need to check the box to enable motion detection function.
Select a channel from the dropdown list.
Period Motion detection function becomes activated in the specified periods. See
Figure 5-52.
There are six periods in one day. Draw a circle to enable corresponding
period.
Click OK button, system goes back to motion detection interface, click save
button to exit.
Anti-dither
System only memorizes one event during the anti-dither period. The value
ranges from 5s to 600s.
Sensitivity
There are six levels. The sixth level has the highest sensitivity.
Region If you select motion detection type, you can click this button to set motion
detection zone. The interface is shown as in Figure 5-53. Here you can set
motion detection zone. There are four zones for you to set. Select a zone
first and then left drag the mouse to select a zone. The corresponding color
zone displays different detection zone. You can click Fn button to switch
between the arm mode and disarm mode. In arm mode, you can click the
direction buttons to move the green rectangle to set the motion detection
zone. After you completed the setup, click ENTER button to exit current
setup. Do remember click save button to save current setup. If you click
ESC button to exit the region setup interface system will not save your
zone setup.
Record channel System auto activates motion detection channel(s) to record once an alarm
occurs. Note you need to set motion detect record period and go to
Storage-> Schedule to set current channel as schedule record.
Record Delay
System can delay the record for specified time after alarm ended. The
value ranges from 10s to 300s.
Alarm out Enable alarm activation function. You need to select alarm output port so
that system can activate corresponding alarm device when an alarm
occurs.
Latch
System can delay the alarm output for specified time after an alarm ended.
The value ranges from 1s to 300s.