User manual

136
5.8.2.14 Auto Register
The auto register interface is shown as below. See Figure 5-38.
This function allows the device to auto register to the proxy you specified. In this way, you can
use the client-end to access the DVR and etc via the proxy. Here the proxy has a switch function.
In the network service, device supports the server address of IPv4 or domain.
Follow the steps listed below to use this function.
Set proxy server address, port, and sub-device name at the device-end. Enable the auto register
function, the device can auto register to the proxy server.
Figure 5-38

5.8.2.15 Alarm Centre
The alarm centre interface is shown as below. See Figure 5-39.
This interface is reserved for you to develop. System can upload alarm signal to the alarm centre
when local alarm occurs.
Before you use alarm centre, set server IP, port and etc. When an alarm occurs, system can send
out data as the protocol defined, so the client-end can get the data.
Figure5‐39
5.8.2.16 HTTPS
In this interface, you can set to make sure the PC can successfully login via the HTTPS. It is to
guarantee communication data security. The reliable and stable technology can secure the user
information security and device safety. See Figure 5-40.
Note
 You need to implement server certificate again if you have changed device IP.
 You need to download root certificate if it is your first time to use HTTPS on current
PC.
Figure5‐40