User manual
135
Refer to the following sheet for detailed information.
Parameter Function
SNMP Port The listening port of the proxy program of the device. It is a UDP port
not a TCP port. The value ranges from 1 to 65535. The default value
is 161
Read Community
It is a string. It is a command between the manage process and the
proxy process. It defined the authentication, access control and the
management relationship between one proxy and one group of the
managers. Make sure the device and the proxy are the same.
The read community will read all the objects the SNMP supported in
the specified name. The default setup is public.
Write Community
It is a string. It is a command between the manage process and the
proxy process. It defined the authentication, access control and the
management relationship between one proxy and one group of the
managers. Make sure the device and the proxy are the same.
The read community will read/write/access all the objects the SNMP
supported in the specified name. The default setup is write.
Trap address
The destination address of the Trap information from the proxy
program of the device.
Trap port
The destination port of the Trap information from the proxy program of
the device. It is for the gateway device and the client-end PC in the
LAN to exchange the information. It is a non-protocol connection port.
It has no effect on the network applications. It is a UDP port not TCP
port. The value ranges from 1 to 165535. The default value is 162.
SNMP version
Check V1, system only processes the information of V1.
Check V2, system only processes the information of V2.
5.8.2.13 Multicast
The multicast interface is shown as in Figure 5-37.
Multicast is a transmission mode of data packet. When there is multiple-host to receive the same
data packet, multiple-cast is the best option to reduce the broad width and the CPU load. The
source host can just send out one data to transit. This function also depends on the relationship
of the group member and group of the outer.
Figure5‐37