User manual

129
5.8.2.5.2 Mobile
The mobile setup interface is shown as in Figure 5-29.
Here you can activate (send out “on”) or turn off (Send out “off”) the 3G connected phone or
mobile phone, or the phone you set to get alarm message.
Check send SMS box and then input the phone number in the receiver column. Click to add
one receiver. Repeat the above steps you can add more phones. Select a phone number and
then click
, you can delete it. Click OK button to complete the setup.
Figure5‐29
5.8.2.6 PPPoE
The PPPoE interface is shown as in Figure 5-30.
Input the PPPoE user name and password you get from the IPS (internet service provider) and
enable PPPoE function. Save current setup and then reboot the device to get the setup activated.
Device connects to the internet via PPPoE after reboot. You can get the IP address in the WAN
from the IP address column.
Note, you need to use previous IP address in the LAN to login the device. Go to the IP
address item to via the device current device information. You can access the client-end
via this new address.
Figure5‐30
5.8.2.7 DDNS
The DDNS interface is shown as in Figure 5-31.
The DDNS is to set to connect the various servers so that you can access the system via the
server. Go to the corresponding service website to apply a domain name and then access the
system via the domain. It works even your IP address has changed.
Select DDNS from the dropdown list (Multiple choices). Before you use this function, make sure
your purchased device support current function.