User manual

122
Color mode It includes several modes such as standard, color. You can select
corresponding color mode here, you can see hue, brightness, and contrast
and etc will adjust accordingly.
Auto Iris It is to enable/disable auto iris function.
Flip It is to switch video up and bottom limit.
This function is disabled by default.
Mirror It is to switch video left and right limit.
This function is disabled by default.
BLC Mode
BLC The device auto exposures according to the environments situation
so that the darkest area of the video is cleared
WDR For the WDR scene, this function can lower the high bright section
and enhance the brightness of the low bright section. So that you
can view these two sections clearly at the same time.
The value ranges from 1 to 100. When you switch the camera from
no-WDR mode to the WDR mode, system may lose several
seconds record video.
HLC After you enabled HLC function, the device can lower the brightness
of the brightest section according to the HLC control level. It can
reduce the area of the halo and lower the brightness of the whole
video.
Off It is to disable the BLC function. Note this function is disabled by
default.
Profile It is to set the white balance mode. It has effect on the general hue of the
video. This function is on by default.
You can select the different scene mode such as auto, sunny, cloudy, home,
office, night, disable and etc to adjust the video to the best quality.
 Auto: The auto white balance is on. System can auto compensate the
color temperature to make sure the vide color is proper.
 Sunny: The threshold of the white balance is in the sunny mode.
 Night: The threshold of the white balance is in the night mode.
 Customized: You can set the gain of the red/blue channel. The value
reneges from 0 to 100.
Day/Night It is to set device color and the B/W mode switch. The default setup is auto.
 Color: Device outputs the color video.
 Auto: Device auto select to output the color or the B/W video according to
the device feature (The general bright of the video or there is IR light or
not.)
 B/W: The device outputs the black and white video.
 Sensor: It is to set when there is peripheral connected IR light.


