User manual

120
Parameter Function
Device
search
Click Device search button, you can view the searched device information on
the list. It includes device IP address, port, device name, manufacturer and
type.
Add
Select a device in the list and then click Add button, system can connect the
device automatically and add it to the Added device list. Or you can double
click one item in the list to add a device.
Modify
Click or any device in the Added device list, you can change the
corresponding channel setup.
Delete
Click
, you can delete the remote connection of the corresponding
channel.
Connection
status
: Connection succeeded.
: Connection failed.
Delete Select a device in the Added device list and then click Delete button, system
can disconnect the device and remove it from the Added device list.
Manual Add
Click it, the interface is shown as in Figure 5-16. Here you can add network
camera manually.
You can select a channel from the dropdown list (Here only shows
disconnection channel.) Note:
 System supports manufactures such as Panasonic, Sony, Dynacolor,
Samsung, AXIS, Arecont, Dahua and Onvif standard protocol.
 If you do not input IP address here. System uses default IP 192.168.0.0
and system does not connect to this IP.
 Can not add two devices at the same time. Click OK button here,
system only connect to the corresponding device of current channel.
5.8.1.2 Conditions
Here you can view device property information. The setups become valid immediately after you
set. See Figure 5-17 (analog channel) and Figure 5-18 (digital channel).
Figure5‐17