User manual

109
When you create a new user, you can input the corresponding MAC address of current user. If
you leave this item in blank, any MAC address user can share this user account to login. Note
system needs to check the validity of MAC. Only the 12-digit 0-f format address can pass the
validity verification. System only saves small character even you input capitalized one. You can
see the corresponding prompt if there is any illegal input.
4.10.5.6 Auto Maintain
Here you can set auto-reboot time and auto-delete old files setup. You can set to delete the files
for the specified days. See Figure 4-135. You can select proper setup from dropdown list.
After all the setups click save button, system goes back to the previous menu.
Figure4‐135
4.10.5.7 Config Backup
The configuration file backup interface is shown as below. See Figure 4-136.
This function allows you to import/export system configuration. You can use this function when
there are several devices need the same setup.
 Export: Connect the peripheral device first and then go to the following interface. Click
Export button, you can see there is a corresponding “Config_Time” folder. Double click the
folder, you can view some backup files.
 Import: Here you can import the configuration files from the peripheral device to current
device. You need to select a folder first. You can see a dialogue box asking you to select a
folder if you are selecting a file. System pops up a dialogue box if there is no configuration
file under current folder. After successfully import, system needs to reboot to activate new
setup.
 Format: Click Format button, system pops up a dialogue box for you to confirm current
operation. System begins format process after you click the OK button.
Note:
 System can not open config backup interface again if there is backup operation in the
process.
 System refreshes device when you go to the config backup every time and set current
directory as the root directory of the peripheral device.
 If you go to the configuration backup interface first and then insert the peripheral device, click
Refresh button to view the newly added device.