Instructions

NOTE: If any further components are found, repeat the
above process until the message “Found new hardware:
Your hardware is installed and configured use” appears.
(c) Now check whether the drivers are installed correctly.
Connect the device to your computer.
Right mouse-click on “My Computer” and left
mouse-click on “Properties”.
Click on the “Hardware tab” and then “Device
Manager”.
In the Device Manager click on the +imaging devices
correctly you should see the “OEM Capture”.
NOTE: If it has a Yellow mark next to it, then this means
that the driver is not installed correctly. In that case
remove the driver and disconnect the device from the
computer. Install the driver again!