Operation Manual
Table Of Contents
- Antenna and Tower Recommendations (if applicable)
- The fans internal to the enclosures help cool the components. The specific fan voltages and part numbers are listed in the Block Diagram included with the Quickstart package.
- Unpacking and Inspection
- FM Amplifier Pallets
- The following is a summary of the typical FM amplifier pallets used in Technalogix power amplifiers and transmitters out of the many pallets that have been designed for production or custom applications. The exact bias and drain currents of your syste...
- PB1A-50-1000-1042H
1
Safeguards
2
Terms and
Warranty
3
Principle of
Operation
4
Installation
5
Operation
6
Control System
7
RF Components
7
RF Components
9
Maintenance
10
Troubleshooting
FM Controls Screen
The FM Controls Screen allows a user to setup audio inputs and FM settings. As
fun as fooling around with the smallest screwdriver you own in the back of a dark
rack sounds, all of these settings can be done from the front touch screen, as
seen in the sample screen below:
Audio Source: As Technalogix FM transmitters include analog and digital
audio inputs as standard, the user can change audio input
sources on the fly and can switch between analog and digital
audio sources. When digital audio is selected, the
Mono/Stereo selection icon changes to allow selection
between the various digital audio inputs (Toslink optical,
coax, AES).
Mono/Stereo: All Technalogix FM transmitters have a stereo encoder built
in to the exciter circuit board. The user can switch between
Mono and Stereo option by simply touching this icon on the
touch screen.
Input Impedance: When analog audio input is selected as a source, the user
can adjust the input impedance of the exciter in the
transmitter between 600 and 10k ohms.