User's Manual

MEAN WELL
SWITCHING POWER SUPPLY
ISO-9001 CERTIFIED MANUFACTURER
PSP-1000
SERIES
.LOW COST, HIGH RELIABILITY .100% FULL LOAD BURN-IN TEST
.BUILT IN EMI FILTER, CURRENT SHARING CIRCUIT .105ºC OUTPUT CAPACITOR
.BUILT IN REMOTE CONTROL, REMOTE SENSE, .BUILT IN PFC CIRCUIT PFC>=0.95,
POWER GOOD SIGNAL COMPLIES WITH EN61000-3-2
.SHORT CIRCUIT, OVERLOAD, OVER VOLTAGE, OVER TEMP. PROTECTED
MODEL
SPECIFICATION
PSP-1000
-5
PSP-1000
-12
PSP-1000
-13.5
PSP-1000
-15
PSP-1000
-24
PSP-1000
-27
PSP-1000
-48
DC OUTPUT VOLTAGE 5V 12V 13.5V 15V 24V 27V 48V
OUTPUT V. TOLERANCE ±2% ±1% ±1% ±1% ±1% ±1% ±1%
OUTPUT RATED CURRENT 145A 75A 67A 60A 37.6A 33.6A 19A
OUTPUT CURRENT RANGE 0-145A 0-75A 0-67A 0-60A 0-37.6A 0-33.6A 0-19A
RIPPLE & NOISE 200mVp-p 200mVp-p 200mVp-p 200mVp-p 200mVp-p 200mVp-p 200mVp-p
LINE REGULATION ±1% ±0.5% ±0.5% ±0.5% ±0.5% ±0.5% ±0.5%
LOAD REGULATION ±2% ±1% ±1% ±1% ±1% ±1% ±1%
DC OUTPUT POWER 725W 900W 904.5W 900W 902.4W 907.2W 912W
PEAK OUTPUT POWER 800W 1000W 1000W 1000W 1000W 1000W 1000W
EFFICIENCY 76% 82% 82% 82% 84% 84% 86%
DC VOLTAGE ADJ. 4.75-5.5V 10-13.2V 12-15V 13.5-18V 20-26.4V 24-30V 41-56V
INPUT VOLTAGE RANGE 90~264VAC 47~63Hz; 127~370VDC
AC CURRENT 14A/115V 7A/230V
POWER FACTOR 0.95/230VAC
INRUSH CURRENT 35A/115V 70A/230V
LEAKAGE CURRENT <2mA/240VAC
OVERLOAD PROTECTION 115%~140% TYPE:CONSTANT CURRENT LIMITING RESET:AUTO RECOVERY
OVER VOLTAGE PROTECTION 5.75~6.75 13.8~16.2V 15.5~18.2V 18~21V 27.6~32.4V 31~36.5V 57.6~67.2V
OVER TEMP.PROTECTION RTH2>=95ºC OUTPUT SHUTDOWN
REMOTE CONTROL RC+/RC-: 0~0.8V=POWER ON; 4~10V=POWER OFF SINK CURRENT 4~10mA
TEMP. COEFFICIENT ±0.03% / ºC (0~50ºC)
SETUP, RISE, HOLD UP TIME 1.5s, 50ms, 15ms
VIBRATION 10~500Hz, 2G 10min./1cycle, PERIOD FOR 60min. EACH AXES
WITHSTAND VOLTAGE I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC
ISOLATION RESISTANCE I/P-O/P, I/P-FG, O/P-FG:500VDC / 100M Ohms
WORKING TEMP., HUMIDITY -10ºC~+60ºC(REFER TO OUTPUT DERATING CURVE), 20%~90% RH
STORAGE TEMP., HUMIDITY -20ºC~+85ºC, 10%~95% RH
DIMENSION 278*129*127mm
WEIGHT 4.7 Kgs
SAFETY STANDARDS MEET UL1950
EMC STANDARDS MEET CISPR22, EN61000-3-2, EN61000-4-2,3,4,5,6,8,11
NOTE : 1.ALL PARAMETERS ARE SPECIFIED AT 230VAC INPUT, RATED LOAD, 25ºC 70% RH. AMBIENT.
2.TOLERANCE GINCLUDE SET UP TOLERANCE, LINE REGULATION, LOAD REGULATION.
3.RIPPLE & NOISE ARE MEASURED AT 20MHz BY USING A 12" TWISTED PAIR TERMINATED WITH A 0.1uF & 47uF CAPACITOR.
4.LINE REGULATION IS MEASURED FROM LOW LINE TO HIGH LINE AT RATED LOAD.
5.LOAD REGULATION IS MEASURED FROM 0% TO 100% RATED LOAD.
6.REFER TO OUTPUT DERATING CURVE VS INPUT VOLTAGE.
7.PEAK OUTPUT POWER LASTING <30 SECONDS WITH A MAX. 10% DUTY CYCLE. 2002-01-28