Installation Manual

cfgNicIpAddress=10.35.10.110

cfgNicGateway=10.35.10.1

This file is updated as follows:

# Object Group "cfgLanNetworking"

[cfgLanNetworking]

cfgNicIpAddress=10.35.9.143

# comment, the rest of this line is ignored

cfgNicGateway=10.35.9.1

The command racadm config -f myfile.cfg parses the file and identifies any errors by line number. A

correct file updates the proper entries. Additionally, you can use the same

getconfig command from the previous

example to confirm the update.

Use this file to download company-wide changes or to configure new systems over the network.

NOTE: "Anchor" is an internal term and do not use it in the file.

Disabling Access to Modify iDRAC7 Configuration Settings on Host

System

You can disable access to modify the iDRAC7 configuration settings through Local RACADM or iDRAC Settings utility.

However, you can view these configuration settings. To do this:

1. In iDRAC7 Web interface, go to Overview → iDRAC Settings → Network → Services.

2. Select one or both of the following:

– Disable the iDRAC Local Configuration using iDRAC Settings — Disables access to modify the configuration

settings in iDRAC Settings utility.

– Disable the iDRAC Local Configuration using RACADM — Disables access to modify the configuration settings

in Local RACADM.

3. Click Apply.

NOTE: If access is disabled, you cannot use Server Administrator or IPMITool to perform iDRAC7

configurations. However, you can use IPMI Over LAN.