Installation Manual

Rollback Firmware Using iDRAC7 Web Interface
To roll back device firmware:
1. In the iDRAC7 Web interface, go to Overview → iDRAC Settings → Update and Rollback → Rollback .
The Rollback page displays the devices for which you can rollback the firmware. You can view the device name,
associated devices, currently installed firmware version, and the available firmware rollback version.
2. Select one or more devices for which you want to rollback the firmware.
3. Based on the selected devices, click Install and Reboot or Install Next Reboot. If only iDRAC is selected, then click
Install.
When you click Install and Reboot or Install Next Reboot, the message “Updating Job Queue” is displayed.
4. Click Job Queue.
The Job Queue page is displayed, where you can view and manage the staged firmware updates.
NOTE:
– While in rollback mode, the rollback process continues in the background even if you navigate away from
this page.
– If iDRAC7 configuration is reset to default values, the iDRAC7 IP address is reset to 192.168.0.120. You can
access iDRAC7 using this IP, or reconfigure the iDRAC7 address using local RACADM or F2 (remote
RACADM requires network access).
An error message appears if:
– You do not have Server Control privilege to rollback any firmware other than the iDRAC or Configure privilege to
rollback iDRAC firmware.
– Firmware rollback is already in-progress in another session.
– Updates are staged to run or already in running state.
If Lifecycle Controller is disabled or in recovery state and you try to perform a firmware rollback for any device
other than iDRAC, an appropriate warning message is displayed along with steps to enable Lifecycle Controller.
Rollback Firmware Using CMC Web Interface
To roll back using the CMC Web interface:
1. Log in to CMC Web interface.
2. Go to Server Overview → <server name>.
The Server Status page is displayed.
3. Click Launch iDRAC and perform device firmware rollback as mentioned in the Rollback Firmware Using iDRAC7
Web Interface section.
61