Installation Manual

Table 15. Default Role Group Privileges

Role Groups Default Privilege Level Permissions Granted Bit Mask

Role Group 1 None Login to iDRAC, Configure

iDRAC, Configure Users,

Clear Logs, Execute Server

Control Commands, Access

Virtual Console, Access

Virtual Media, Test Alerts,

Execute Diagnostic

Commands

0x000001ff

Role Group 2 None Login to iDRAC, Configure

iDRAC, Execute Server

Control Commands, Access

Virtual Console, Access

Virtual Media, Test Alerts,

Execute Diagnostic

Commands

0x000000f9

Role Group 3 None Login to iDRAC 0x00000001

Role Group 4 None No assigned permissions 0x00000000

Role Group 5 None No assigned permissions 0x00000000

NOTE: The Bit Mask values are used only when setting Standard Schema with the RACADM.

Single Domain Versus Multiple Domain Scenarios

If all the login users and role groups, including the nested groups, are in the same domain, then only the domain

controllers’ addresses must be configured on iDRAC7. In this single domain scenario, any group type is supported.

If all the login users and role groups, or any of the nested groups, are from multiple domains, then Global Catalog server

addresses must be configured on iDRAC7. In this multiple domain scenario, all the role groups and nested groups, if any,

must be a Universal Group type.

Configuring Standard Schema Active Directory

To configure iDRAC7 for a Active Directory login access:

1. On an Active Directory server (domain controller), open the Active Directory Users and Computers Snap-in.

2. Create a group or select an existing group. Add the Active Directory user as a member of the Active Directory

group to access iDRAC7.

3. Configure the group name, domain name, and the role privileges on iDRAC7 using the iDRAC7 Web interface or

RACADM.