Installation Manual

Disconnecting SOL Session in iDRAC7 Command Line Console
The commands to disconnect a SOL session are based on the utility. You can exit the utility only when a SOL session is
completely terminated.
To disconnect a SOL session, terminate the SOL session from the iDRAC7 command line console:
• To quit SOL redirection, press <Enter>, <Esc>, and then <t>. The SOL session closes.
• To quit a SOL session from Telnet on Linux, press and hold <Ctrl>+]. A Telnet prompt is displayed. Enter quit to exit
Telnet.
• If a SOL session is not terminated completely in the utility, other SOL sessions may not be available. To resolve this,
terminate the command line console in the Web interface under Overview → iDRAC Settings → Sessions.
Communicating With iDRAC7 Using IPMI Over LAN
You must configure IPMI over LAN for iDRAC7 to enable or disable IPMI commands over LAN channels to any external
systems. If it is not configuration is not done, then external systems cannot communicate with the iDRAC7 server using
IPMI commands.
Configuring IPMI Over LAN Using Web Interface
To configure IPMI over LAN:
1. In the iDRAC7 Web interface, go to Overview → iDRAC Settings → Network.
The Network page is displayed.
2. Under IPMI Settings, specify the values for the attributes and click Apply.
For information about the options, see the iDRAC7 Online Help .
The IPMI over LAN settings are configured.
Configuring IPMI Over LAN Using iDRAC Settings Utility
To configure IPMI over LAN:
1. In the iDRAC Settings Utility, go to Network.
The iDRAC Settings Network page is displayed.
2. For IPMI Settings, specify the values.
For information about the options, see the iDRAC Settings Utility Online Help .
3. Click Back, click Finish, and then click Yes.
The IPMI over LAN settings are configured.
114