Installation Guide

PAGE 1
Plug in and tum on the UV Light to check if it quarks properly. Insert the Pin into the slot at the end of the application tray. Hold the tube over the Indicated position with the opened end Plug the UV Light In and prop If up on His legs, Then tum It Then turn if off. h fusing down. Unscrew the back cap fo release the adhesive 1 on and place ft over the phone. Slowly move the UV Light from the tube. fo cure the whole screen until the UV light Is turned off automatically.
PAGE 2
TECH 2477 Customer Support = hie ida hei STAY CONNECTED Els 43: | got an alr bubble during Installation. What now? A: If the Screen Protector Is already on the phone with the adhesive spread, you will need a replacement Protector. Cure the Protector with the UV light, then remove If and discard. Please send us an meal fora free replacement. 4 The Gel didn’t spread evenly during application, and It's been more than 3 minutes. What do | do? A:Tit the phone In the direction that the Gel needs to go.