Operation Manual

- 33 -
Before Switching On Your TV
Power Connection
IMPORTANT: The TV set is designed to oper-
ate on 230V AC, 50 Hz.
 After unpacking, allow the TV set to reach the
ambient room temperature before you con-
nect the set to the mains.
Connections To The Aerial Input
Socket
 Connect the aerial or cable TV plug to the
Aerial input socket located at the rear of the
TV and connect the cable plug coming out
from the TV out socket located on the devices
(VCR, DVB-T etc.) to this socket as well.
How To Connect Other Devices
IMPORTANT: Switch off the TV before connect-
ing any external device.
Sockets for external connections are at the
rear side of the TV. For connection of other
devices via Scart refer to the manuals of the
related devices.
Inserting Batteries In The Remote
Control Handset
 Remove the battery cover located on the back
of the handset by gently pulling downwards
from the indicated part.
 Insert two AAA/R03 or equivalent type batter-
ies inside. Place the batteries in the right
directions.
 Replace the battery cover.
NOTE: Remove the batteries from remote con-
trol handset when it is not to be used for a long
period.Otherwise it can be damaged due to
any leakage of batteries.
Switching The TV ON/OFF
To switch the TV on:
Your TV will switch on in two steps:
1- Connect the power supply cord to the sys-
tem. Press Power On/Off switch 
 located
by the mains input socket. Then the TV
switches itself to stand-by mode and the
LED on the front of the TV becomes RED.
2- To switch on the TV from stand-by mode
either:
Press a digit button on the remote control so
that a programme number is selected,
or,
Press  , "+P/CH" or "P/CH-" button at the top
of the TV or press the 
, - P or P + button
on the remote control, so that last mode
switched off is selected.
By either method the TV will switch on and the
LED is BLUE.
To switch the TV off:
 Press the  (stand-by) button on the re-
mote control, so the TV will switch to stand-
by mode and the LED will become RED.
To power down the TV completely, press On/
Off switch 
,
or,
Unplug the power cord from the mains socket.
02-ENG-37735-1072 UK-37 INCH 17MB15 OEM-(WO VGA)(PIP)(S)-50097076.p65 20.11.2006, 19:4133