Operation Manual

- 31 -
Preparation
Install Display on solid horizontal surface such as a table or desk.
For ventilation, leave a space of at least 10 cm free all around the set. To prevent any fault
and unsafe situations, please do not place any objects on top of the set.
This apparatus can be used in tropical and/or moderate climates.
Installation Of The TFT TV To The Wall (optional)
1- To install the TFT TV on the wall, first of all, foot assembly should be removed. (Figure 1).
Unscrew the 3 screws (M4 x 6) that attach the foot assembly to the TFT panel and remove the
foot assembly from the TFT panel.
2- Place the 4 plastic pins to the circular screw holes at the rear of the TFT and screw them to
the TFT panel with 4 (6 x 23) screws.
3- Decide the place on the wall
where the TFT panel would be
placed. Fix the stencil wall mount
(shown in Figure 2) on the wall.
The stencil wall mount is used for
placing the wall hangers on the wall,
properly.
4- Level and mark with a pencil the 4
mounting points on each wall
hanger.
Drill pilot holes for the plastic an-
chors (7x30) and then fix the wall
hangers with 8 screws (4 x 30).
5- Raise the TFT panel and hang it to
the holes on the wall hanger from the
4 hanging screws at the rear of the
TFT panel.
FIGURE 1
FOOT ASSEMBLY
SCREW HOLES
FOR PLASTIC PINS
TFT PANEL
02-ENG-27700-1072 UK-27 INCH 17MB15 OEM-(WO VGA)(SAM)-50082232.p65 11.05.2006, 17:1331