User's Manual

observe the following precautions.
Safety Precautions for RF Exposure
Tests for SAR are conducted using standard operating positions specified by the FCC
with the phone transmitting at its highest certified power level in all tested frequency
bands. Although the SAR is determined at the highest certified power level, the actual
SAR level of the phone while operation can be well below the maximum value. This is
because the phone is designed to operate at multiple power levels so as to use only the
power required to reach the network. In general, the closer you are to a wireless base
station antenna, the lower the power output. Before a phone model is available for sale
to the public, it must be tested and certified to the FCC that it does not exceed the limit
established by the government-adopted requirement for safe exposure. The tests are
performed in positions and locations (for example, at the ear and worn on the body) as
required by the FCC for each model. (Body-worn measurements may differ among
phone models, depending upon available accessories and FCC requirements). For
body worn operation, to maintain compliance with FCC RF exposure guidelines, use
only original manufacturer approved accessories. When carrying the phone while it is
on, use the specific original manufacturer supplied or approved carrying case, holster,
or other body-worn accessory.
General Precautions
• Heed service markings
Except for explained elsewhere in the Operating or Service documentation, do
not service any product yourself. Service needed on components inside these
compartments should be done by an authorized service technician or provider.
• Damage requiring service
Unplug the product from the electrical outlet and refer servicing to an authorized
service technician or provider under the following conditions:
. • Liquid has been spilled or an object has fallen into the product.
. • The product has been exposed to rain or water.
. • The product has been dropped or damaged.
. • There are noticeable signs of overheating.
. • The product does not operate normally when you follow the operating
instructions.
• Avoid hot areas
The product should be placed away from heat sources such as radiators, heat
registers, stoves, or other products (including amplifiers) that produce heat.
• Avoid wet areas
Never use the product in a wet location.
• Avoid pushing objects into product
Never push objects of any kind into cabinet slots or other openings in the product.
Slots and openings are provided for ventilation. These openings must not be
blocked or covered.
• Mounting Accessories
Do not use the product on an unstable table, cart, stand, tripod, or bracket. Any
mounting of the product should follow the manufacturer’s instructions, and
should use a mounting accessory recommended by the manufacturer.
• Avoid unstable mounting