User's Manual

69
☺ Note: WLAN (Wi-Fi) is the default wireless channel setting for your device. However, GPRS starts by default if your device does not detect any Wi-Fi signal.
To connect to a Wi-Fi network
• Tap Start > File Explorer, find My Device, and then tap to enter the cetk folder.
• Tap Wlanloader to run it. On the screen, tap the Load box to activate driver. Now, it starts searching networks. Tap Start >Settings > Connections tab >
Wireless Manager, you can see an option named Wi-Fi there, with its status (On/Connecting/Available) under it.
Highlight Wi-Fi, tap Menu, and then select Wi-Fi settings to configure wireless networks.
You can see a list of network names with their status behind. In additional, you can choose to add new network from here.
Tap the Networks to access box to specify a network type.
Once some networks are detected, it pops up a list from the bottom asking you to select one to connect.
To save battery power while connected to a Wi-Fi network
• On the Connections tab in Settings, tap to run Cheetah. Move the Power Save Mode slider to a position that optimizes performance with the least power
consumption.
• In Power Save Mode box, choose how you deploy the power save mode.