User's Manual

64
☺ Note: WLAN (Wi-Fi) is the default wireless channel setting for your device. However, GPRS starts by default if your device does not detect any Wi-Fi signal.
WLAN transmitter can’t operate simultaneously with the GSM/GPRS transmitter. So it is not capable of using both transmitters at the same time.
To connect to a Wi-Fi network
• Tap Start > Settings>Connections Tab>Wi-Fi settings
• Tab Main tab .Input Status、Current Configuration and Signal Quality.
• Tab Ok.
• Tap Start >Settings > Connections tab > Wireless Manager, you can see an option named Wi-Fi there, with its status (On/Connecting/Available) under it.
Highlight Wi-Fi, tap Menu, and then select Wi-Fi settings to configure wireless networks.
Once some networks are detected, it pops up a list from the bottom asking you to select one to connect.
To save battery power while connected to a Wi-Fi network
• On the Connections tab in Settings, tap Wi-Fi settings to enter Settings. You can select three modes: Always Disable; Always Enable ; and Auto Enable
.Moreover you can move the Power Save Mode slider to a position that optimizes performance with the least power consumption.
• In Power Save Mode box, choose how you deploy the power save mode.