User's Manual

ID Setting
1. Take one battery out from remote controller, press any key then reload
battery.
2. The red LED indicator at front panel lights up for 5 seconds.
3. Within 5 seconds, enter a set of 4 numbers to finishes digital ID setup
Note:
There are 10000 combination of digital ID code range from 0000 to
9999. User may change it when desire. Please note that the digital ID
code must correspond to the chosen light, wall and power switch’s ID
enable for controller to control them.
ID check
1. Press and hold key.
2. Press and count the number of times red LED indicator blinks, which
represent the first digit of the code. Repeat step with , and to check
for other digits.
Note:
The factory default code of the remote controller is “0000”. User need
to change the code correspond to light switch’s digital ID or power
plug ID to enable the RC-06 Smart Remote Controller to control them.