User's Manual

RC-09 User Manual

Mode Name : RC-09

Battery : AAA*2

Frequency : 433.92MHz

Device Keys

Setting Keys

Active Keys

FCC Caution :

To assure continued compliance, any changes or modifications not expressly

approved by the party responsible for compliance could void the user's authority to

operate this equipment. (Example - use only shielded interface cables when

connecting to computer or peripheral devices).

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(

)

This device ma

not cause harmful interference

and

(

)

This device must

accept any interference received, including interference that ma

cause undesired

operation.

PAGE 1
RC-09 User Manual Mode Name : RC-09 Battery : AAA*2 Frequency : 433.92MHz FCC Caution : To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices). This device complies with Part 15 of the FCC Rules.
PAGE 2
ID Setting 1. Take one battery out from remote controller, press any key then reload battery. 2. The red LED indicator at front panel lights up for 5 seconds. 3. Within 5 seconds, enter a set of 4 numbers to finishes digital ID setup Note: There are 10000 combination of digital ID code range from 0000 to 9999. User may change it when desire. Please note that the digital ID code must correspond to the chosen light, wall and power switch’s ID enable for controller to control them. ID check 1.
PAGE 3
Lighting Control Note: Please make sure the chosen light, wall or power switch’s digital ID code is consistent with RC-09’s digital ID code. or 1. Select the control Zone of 2. Press device key from to and within 5 seconds, press then release, red LED indicator will light up or to send command, red LED indicator will blink once. 3.
PAGE 4
- + or Setting Keys Learn+Devices Key : going to device Learning Mode Set+No.1 or 2 or 3 or 4: check the RC-09’s ID Learn+MACRO : going to MACRO edit mode Set+Off : clear the memory MACRO+No.