User's Manual

e2-Live Home Automation
Edit by Shine Lo
11
Power current detection setting :
Step 1 Step 2 Step 3 Step 4
Plug the corresponding appliance in iPower socket, adjust the current knob of appliances one by one.
1.) When the socket connector, without Transformer / stabilizer of equipment
→ Adjust the knob to the small load direction limition.
※ Such equipment almost no power consumption in standby mode, when the equipment is power
on (Relay ON) iPower can detect its current power (if the current power > 5w)
2.) When the socket connector, with Transformer / stabilizer of equipment
a.) Plug in the equipment, turn on iPower and the equipment.
b.) Use flat head screw driver to adjust red LED light on. Then turn the knob back let LED just
light off., this was the correct position the power on current consumption can be detected
c.) Verification:
i) Turn off the appliance (load no electricity); LED indicator → [Bright]
. ii) Open the appliance (loaded with electricity); LED indicator → [OFF]
※ transformer / ballast itself in the standby mode already has power, if not through the
current limitation adjustment, iPower can not properly judge the current electrical load is in
working electricity mode or in Standby mode.
Red LED light on : the device is power off
Red LED light off : the device is power on
Plug in appliance
in iPower socket,
Press button to
provide power to
this device (blue
LED light off)
Turn on the device
power (in operation
mode, not in standby
mode)
Use flat head screw
driver to adjust red
LED light on. Then
turn the knob back
let LED just light off.
Manual or remote to turn off
the device power
Red LED light on
Then turn on the device to
see red LED light off .
The setting is done