User's Manual

Note:

1. This product should be programmed by RC-07.

2. Please contact the distributor near you to obtain correct/updating of product information.

3. Please refer to each manual of HC-12/RP-12/RP-10 for the details of scene (macro) setting.

4. Appliances Activatation Setup

A. Procedure:

a. Press & hold a key, punch Setup Button with a Setup Stick (punch – feel a click & let go), after

LED flash 3 times & off, use setup stick to punch the setup button again, & observe the LED blinking.

The Sequence

of Blinking

1st 2nd 3rd 4th 5th 6th 7th 8th 9th 10th

Constant ON

for 1 Sec.

Macro No. 1 2 3 4 5 6 7 8 9 10 Clear

C. As above table, press any key as LED blinking sequence no. indicates the macro you want to

assign. & it will confirm the assignment with blinking LED with times as the macro no. you’ve

choose. ex.: If the linked macro no. 7, is what you need; when the LED blinks the 7

, touch any key

on LS-330T panel, & the LED will blink 7 times to confirm the macro you’ve selected.

At last, the 3 LED will blink 2 times together to leave the setting mode.

- If you touch any key as the LED ON for 1 Sec., it means “Clear”, no linked macro code assigned in

this setting.

- The setting cycle is once at a time, if you do nothing under setting mode. The system will be

recovery after LED blinks 10 times & constant ON for 1 Sec.

B. Control:

a.) Touch the key to send a Linked Macro Activating Code to a controller nearby, after it finished all

its preset 2-Way / Macro Control action.

b.)

Touch any key to break off the action as LC-X0T is transmitting actions.

Annex A：Panel Install / uninstall

[Uninstall]

Put the sucker on the marked spot, press to squeeze out air

& make sure the sucker is fixed, then pull out of the panel.

[Install]

There are 2 latches on the top of the panel, & a crystal in the

buttom. there is 2 slot for those 2 latches & a magnet for

crystal. PLS make sure the direction correctly. Slide latches

into slots first then press the crystal side into the magnet side

till the panel sink completely.

Pull！