User's Manual

--------------------------------------------------------------------------------------------------------------------------------

1. Forward/Reverse: Touch [Forward]/[Reverse] the relay will close according the time you’ve set.

2. Press [Forward]; while the relay is still closing, touch [STOP] or [Reverse], relay will open.

3. Press [Reverse]; while the relay is still closing, touch [STOP] or [Forward], relay will open.

4. Follow [2.] & [3.], touch [Forward] or [Reverse], LC-330C will restart route counting till the action is interrupted

or the time is up & the relay is recovered to the open mode.

5. Reverse Code control: some of e2-LiVE’s remote controllers can transmit reverse code to control

LC-330C(ex. BT-100, CS-330T, MS-X0T, LS-X0T…, etc.) which can use only one key to control LC-330C.

For example, One press the remote button, LC-330C the [Forward] relay is closed, will act reversely. Press

the same remote button again, the relay will open. Press the same remote button, [Reverse] relay will close…

6. Control with an e2-LiVE remote controller: a.) choose Zone b.) choose position c.) press ON/OFF to control.

Note: Remote controller has no STOP button, we use ON/OFF to remote control LC-330C.

Ex.: Press ON – LC-330C’s the Forward relay is closing, press OFF the relay will open. Press OFF

again the Reverse relay will close…

Operation

Annex A：Install / uninstall Panel

[Uninstall]

Put the sucker on the marked spot, press to squeeze out air

& make sure the sucker is fixed, then pull out of the panel.

[Install]

There are 2 latches on the top of the panel, & a crystal in the

buttom. there is 2 slot for those 2 latches & a magnet for

crystal. PLS make sure the direction correctly. Slide latches

into slots first then press the crystal side into the magnet side

till the panel sink completely.

Pull！