User's Manual

2
Setting
A. Set ID & Position
1. You may use any remote controller of
to input
(set) ID & position to LC-330C
2. Use haptor to remove the panel.
(Please check appendix for the details)
3. Use setup stick to push & let go SET button, buzzer
Bi a sound, LED indicator blink 3 times & turn off.
Now it’s under learning mode
4. Pick up a remote controller, press a NO. key then press
ON. (ex. Press Zone 1, No.1 & ON)
5. LC-330C will record the ID & position of the remote
controller, buzzer Bi twice, LED indicator blink twice then
goes off – the learning is done.
6. If you don’t press any button within 10 second, buzzer will
make a long Bi then exit the learning mode.
B. Route Setting：This is the way to control the period of motor spinning forward/reverse for the reason of power saving.
1. Enter Learning Mode: Use setup stick to push & let go SET button, buzzer Bi a sound, LED indicator blink 3 times &
turn off. Now it’s under learning mode
2. Enter Route Learning Mode: Use setup stick to push & let go SET button again. At this moment, all LEDs are ON.
3. Touch Key 1(forward) once, buzzer will start to count the timing with Bi in every second & 3 LEDs blink. (The count
will be going till 255 seconds Max.)
4. When the count reach the timing of you need, press STOP.
Buzzer will Bi twice & LEDs stop blinking – the route is set.
[Ex. 1] Set the route of curtain
a. Enter Learning Mode
b. Zero the curtain: Press key2 (Reverse) till the curtain completely open/close.
b. Enter Route Learning Mode
c. Start to set the route: Touch Key 1(forward) once, buzzer & LED will start to count. Touch STOP as the curtain
completely close/open.
[Ex. 2] Trigger other device – relay touch 1 second & recover (open)
a. Enter Learning Mode
b. Enter Route Learning Mode
c. Set Relay Touch Time: Touch Key 1(forward) once, buzzer & LED will start to count. While LED blinks & buzzer
Bi one time, touch STOP to stop the count.
C. Set Relay Always Close (Cancel Route Time)
a. Enter Learning Mode
b.
Enter Route Learning Mode
c.Touch Key 1(forward) once & touch STOP before Buzzer & LED start to count.
Note: This setting will makes the relay always close as you touch Forward/Reverse, unless you touch [STOP].
REMARK!
1. The Route Time is 1~255 second, the default is 90 second.
2. The Route Time of Forward /Reverse is same.
3. We strongly suggest LC-330C should be collocated with those product obtains limit switch function.
4. When all settings are completed. There are 30 seconds window for the touch sensor re-scan after
front panel mount on. After 30 seconds, you may touch & control the panel normally.