Installation Instructions

1.0

Installation Instructions for

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing compliant junction boxes.NEC

This product may be dimmed with a low-voltage electronic

dimmer.

WCALL OLLECTION

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Install the Fixture

Remove the fixture screws located on the top and

bottom of the fixture base.

Remove the mounting plate from the fixture base.

FIXTURE SCREW

MOUNTING

PLATE

FIXTURE SCREW

ELECTRICAL BOX

Install the mounting plate onto the electrical box with

the two #8-32 screws provided.

#8-32 SCREW

Bath

PAGE 1
Installation Instructions for Bath 1.0 W ALL C OLLECTION GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product may be dimmed with a low-voltage electronic dimmer. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. Use minimum 90°c supply conductors.
PAGE 2
1C 6 4 5 4 Connect the mounting plate ground wire to a suitable ground in accordance with local electrical codes. 5 Connect the black fixture wire to the hot power line wire with a wire nut. 6 Connect the white fixture wire to the neutral power line wire with a wire nut. 7 Properly place all wires and wire nut connections into the fixture base. 8 Mount the fixture by sliding it back onto the mounting plate and reinstalling the fixture screws (reversal of figure 1A).