Installation Instructions

2
2A
3
3
2
1
DRIVER
Connect the backplate wire to a suitable ground in
accordance with local electrical codes.
Connect the white driver wire to the neutral power line.
Connect the black driver wire to the hot power line.
Use the gray and purple dimming wires for 0-10v
dimming application.
1
2
3
4
4
Install the Fixture
2B
6
5
Properly place the driver, all wires, and wire nut
connections into the canopy.
Hook the top of the fixture to the top of the mounting
plate and swing the bottom of the fixture toward the
plate until it is flush with the wall.
Tighten the set screw at the bottom of the fixture.
7
ALLEN WRENCH
SET SCREW
7
8
Remove only the protective film.CLEAR
CLEAR FILM
2C
NOTE: The purple and gray wires are only used
for 0-10v dimming. For all other applications, do
not connect the gray and purple wires.
WARNING: DO NOT REMOVE THE WHITE ADHESIVE
FILM REMOVE THE
from the of this fixture. OnlySIDES
TRANSPARENT PROTECTIVE FILM which is located on the
TOP AND BOTTOM of the fixture.
WARNING: DO NOT REMOVE THE WHITE ADHESIVE
FILM
from the of this fixture. OnlyTOP AND SIDES
REMOVE THE TRANSPARENT PROTECTIVE FILM
which is located on the of the fixture.BOTTOM
FOR DIRECT VERSIONS ONLY
FOR DIRECT/INDIRECT VERSIONS ONLY