Installation Instructions

1
GP I :ENERAL RODUCT NFORMATION
This fixture are intended to be installed utilizing
NEC compliant junction boxes.
Suitable for damp locations.
This product may be dimmed with a low-voltage electronic
dimmer, dimmer, or a 0-10V dimmer depending onTRIAC
the wiring configuration.
This product may be mounted horizontally or vertically.
Install the Back Plate
1A
2
1
With the Allen wrench provided, back out (do not fully
remove) the set screw at the base of the fixture.
Remove the mounting plate from the back of the
fixture.
ALLEN WRENCH
SET SCREW
MOUNTING
PLATE
1
1B
3
3
Attach the mounting plate to the electrical box using
the two provided #8-32 screws .
3
3
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
BCATH OLLECTION
SAVE THESE INSTRUCTIONS!
WARNING: DO NOT REMOVE THE WHITE ADHESIVE
FILM REMOVE THE
from the of this fixture. OnlySIDES
TRANSPARENT PROTECTIVE FILM which is located on the
TOP AND BOTTOM of the fixture.
WARNING: DO NOT REMOVE THE WHITE ADHESIVE
FILM
from the of this fixture. OnlyTOP AND SIDES
REMOVE THE TRANSPARENT PROTECTIVE FILM
which is located on the of the fixture.BOTTOM
FOR DIRECT VERSIONS ONLY
FOR DIRECT/INDIRECT VERSIONS ONLY
Installation Instructions