Installation Instructions

Installation Instructions for
1
GP I :ENERAL RODUCT NFORMATION
This fixture is intended to be installed utilizing NEC
compliant junction boxes.
This product is suitable for damp locations.
This product can be dimmed with a low-voltage electronic
dimmer.
1A
Remove the shade by sliding it all the way over to
release it from the keyhole slot, then carefully pull it
straight out.
1
Prepare the Fixture
1B
Unscrew the two thumb screws to separate the
mounting plate from the backplate.
2
SHADE
KEYHOLE SLOT
THUMB SCREW
MOUNTING PLATE
BACKPLATE
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
NOTE: If plaster ring holes are horizontal or
mounting onto a octagon electric box, skip to
section 3.
NOTE: If mounting vertically, skip to section 4.
Back Plate Installation (Horizontal)
2A
ELECTRICAL BOX
1
2
BACK PLATE
2
3
Connect the white fixture wire to the neutral power line
wire with a wire nut.
Connect the black fixture wire to the hot power line
wire with a wire nut.
Connect the fixture to a suitable ground in accordance
with local electrical codes.
1
2
2
13 and 25 Bath

Summary of content (4 pages)