Installation Instructions

4
SAVE THESE INSTRUCTIONS!
Remove the four #6 screws on the front of the 2"
electrical box.
Remove the front cover.
Place the 2" electrical box into the square cut out.
#6 SCREW
Replace the front cover.
Replace and tighten the four #6 screws on front cover
completely so that the spring tabs on the side of the 2"
electrical box push out against the drywall and secure
the box in place.
3D
#6 SCREW
3C
7
8
9
7
9
10
11
10
11
4A
Connect the fixture wires to the low-voltage wires
coming from the remote transformer in the 2" electrical
box with wire nuts.
1
Install the Fixture
4B
Place the fixture onto the electrical box, align the
mounting holes, and secure it in place with the fixture
screws.
2
FIXTURE
SCREW
1
1
All rights reserved.