Installation & Assembly

4C7C

Install the Faceplate

Install the provided double-sided tape onto the back of

the faceplate as shown. NOTE: Press firmly on the

double-sided tape to ensure it is properly stuck on

the faceplate.

DOUBLE-

SIDED TAPE

FACEPLATE

Install the insert into the faceplate and secure it in place

by pressing it firmly against the double-sided tape.

FACEPLATE

INSERT

Install the faceplate onto the insert and secure it in

place by turning the screws on each side of the

faceplate ; make sure to evenlycounter clockwise

tighten the screws to properly center the faceplate.

4C7A

4C7B

Ensure that the weatherproof gasket is place and install

the fixture into the housing.

Without tightening, install the fixture screws to hold the

unit in place.

Level the fixture, then tighten the fixture screws.

Install the Fixture

Remove the cover plate (if applicable).

Connect the ground wire to a suitable ground in

accordance with local electrical codes.

Connect the white unit wire to the neutral power line

with a wire nut.

Connect the black unit wire to the hot power line with a

wire nut.

Note: Ensure that the fixture has been installed properly

and that the mortar or concrete has completely dried

before continuing the installation.

4C6A

FIXTURE

SCREW