Installation Sheet

4
©2021 Tech Lighting, L.L.C. All rights reserved. The Tech Lighting logo is a registered trademark of Tech Lighting.
Tech Lighting reserves the right to change specifications for product improvements without notification.
7400 Linder Ave., Skokie, IL 60077
T 847.410.4400 | F 847.410.4500
www.techlighting.com
8C
Install the reflector by inserting it into the bottom of the
Cylinder and screw it in as far as it will go.
6
8A
Remove the reflector by gripping the interior of the
reflector and rotate counter-clockwise.
Save the optic and discard the reflector.
1
Install the Reflector Accessory
2
8B
In the accessory reflector place the first lens or louver.
If only using one lens then place the spacer, else place
the second lens.
Then rest the optic on top of the second lens or spacer.
3
4
5
OPTIC
LENS/SPACER
LENS/LOUVER
REFLECTOR
7A
For the adjustable only: push up or pull down where the
label is located to tilt the lower cylinder to the desired
angle (o°-45°)
1
Adjust the Angle (Adjustable only)