Installation Sheet

2A1A

Installation Instructions for

920ECDLED

Install the Crossbar

Mount the crossbar to the junction box with the

provided #8-32 screws.

8-32 SCREW

JUNCTION BOX

CROSSBAR

For Optional Stem: If the optional stem was ordered

feed the wiring through the stem first and screw the

stem to the top of the fixture.

Feed the wiring through the canopy, lock washer and

hex nut, in that order. Then fasten the canopy to the

fixture or stem by tightening the lock washer and hex

nut to the nipple.

Surface and Pendant Mount

CAUTION RISK OF FIRE-

This product must be installed in accordance with the

applicable installation code by a person familiar with

the construction and operation of the product and the

hazards involved.

Use minimum 90°C supply conductors.

GP I :ENERAL RODUCT NFORMATION

This product is suitable for damp locations.

This product can be dimmed with a standard electronic

dimmer or 0-10V dimmer.

This instruction shows a typical installation.

ENTRA CYLINDER

1.0

CANOPY

LOCK WASHER

HEX NUT

STEM

NIPPLE

FIXTURE

NIPPLE

Assemble the Fixture

1 1

SAVE THESE INSTRUCTIONS!

ECD_

1.2

PAGE 1
920ECDLED Installation Instructions for Surface and Pendant Mount ECD_ 1.0 1.2 ENTRA CYLINDER GENERAL PRODUCT INFORMATION: This product is suitable for damp locations. This product can be dimmed with a standard electronic dimmer or 0-10V dimmer. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. This instruction shows a typical installation.
PAGE 2
Wire the Fixture Connect Power to the Housing (Remote Drivers) 3A 4A 1 1 ELECTRICAL BOX COVER N H 2 0-10V REMOTE DRIVER ELECTRICAL BOX 1 Open remote driver junction box by removing 2 screws. 2 Connect conduit or Romex to junction box with the proper fittings 3 Use the wiring diagrams to wire your fixture accordingly. Wiring Diagrams (Remote Drivers) 1 Use the following wiring diagram to wire your fixture. 2 Make sure to cap 0-10V dimming wires if not being used.
PAGE 3
Wiring Diagrams (Remote Drivers cont.) Install the Fixture 5A WARNING: Do not connect red and blue wires from fixture to line voltage.
PAGE 4
Adjust the Angle (Adjustable only) 8B 7A OPTIC LENS/SPACER LENS/LOUVER REFLECTOR 3 In the accessory reflector place the first lens or louver. 4 If only using one lens then place the spacer, else place the second lens. 5 Then rest the optic on top of the second lens or spacer.