Installation Sheet

8
Adjust the Module
(Adjustable Versions Only)
Using your fingers, adjust the direction of the light
making sure to turn the module not the reflector
(see note below).
SQUARE ADJUSTABLE SHOWN
8A
1
LIGHT MODULE
REFLECTOR
NOTE: The light module may be rotated up to 45
degrees when inside the housing. Remove the module
from the housing to rotate another 45 degrees if
necessary, then carefully reinstall the module into the
housing.
©2020 Tech Lighting, L.L.C. All rights reserved. The Tech Lighting logo is a registered trademark of Tech Lighting.
Tech Lighting reserves the right to change specifications for product improvements without notification.
7400 Linder Ave., Skokie, IL 60077
T 847.410.4400 | F 847.410.4500
www.techlighting.com
Install or Replace Optics and Lenses/Louvers
Unscrew and remove the optic holder from the light
module.
Remove the old optic.
If installing a lens or louver, remove the rubber gasket
from the optic holder to allow room for lens or louver
installation. If not installing a lens or louver, skip this
step. NOTE: Only one lens or louver may be installed
at a time. Warm Dim Light Module ships standard
with diffusing Lens, recommended for optimal color
mixing.
Install the new optic into the optic holder.
Make sure the lens, louver, optic or gasket are
properly seated in the optic holder, then screw the
optic holder back onto the light module
9A
1
LIGHT MODULE
OPTIC
HOLDER
OPTIC
2
3
4
5
LENS/LOUVER
(OPTIONAL)
NOTE: Warm Dim Units include optional lens for
installation at the light engine aperture for optimal
color mixing, see step 9A of the Instructions below.