Installation Sheet

Assemble the Fixed or
Adjustable Trim/Light Module
5A
Press the spring clips inward and feed the reflector
through the trim until they snap together.
1
5B
Carefully snap light module and reflector together.
Alignment arrows are provided on the adjustable
versions. Directional alignment is not required for
fixed Versions.
2
SQUARE SHOWN
SQUARE SHOWN
TRIM
(SEE NOTE)
REFLECTOR
SPRING CLIP
LIGHT
MODULE
REFLECTOR
ARROWS
6
NOTE: Trim is included with flanged versions only.
Skip this step for flangeless versions where plaster
ring is provided.
Snap light module and wall wash reflector together
Assemble the Wall Wash Light Module
Remove and discard optic holder and optic from
fixed light module.
6A
1
LIGHT MODULE
OPTIC
HOLDER
OPTIC
6B
LIGHT MODULE
WALL WASH
REFLECTOR
2
NOTE: Trim is included with flanged versions only.
Skip this step for flangeless versions where plaster
ring is provided.