Installation Sheet

1A
Install the Housing with Adjustable Bars
1
2
3
Determine which direction the adjustable bars need
to be mounted, they can either be mounted
horizontally or vertically.
Slide the inner adjustable bar completely through the
two slots. Make sure flange at bottom of hanger bar
ends is orientated with the bottom of the housing.
Slide and push the outer adjustable bar completely
onto the inner adjustable bar so that the tab clicks
into place behind the stop point. This will prevent the
adjustable bars from coming apart.
Repeat steps 1 & 2 for the other side of the housing.
1B
NOTE: The adjustable bars can be mounted to joists
that are spaced 16" - 24" apart.
Align the bottom of the end plates with the bottom
of the ceiling joists.
Level the adjustable bars and, with a hammer, tap the
nails completely into the joists to secure the
adjustable bars in place.
5
6
COLLAR/HOLE
NAIL
JOIST
5
6
5
5
6
NAIL
6
3
2
2
2
2 2
2
TAB
STOP POINT
3
4
INNER ADJUSTABLE BAR
OUTER ADJUSTABLE BAR
INNER ADJUSTABLE BAR
NAIL
NAIL
OUTER ADJUSTABLE BAR
2
22