Installation Instructions

Installation Instructions for

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Install the Fixture

Remove the fixture screws located on the top and

bottom of the fixture base with the provided Allen

wrench.

Remove the mounting plate from the fixture base.

Install the mounting plate onto the electrical box with

the two #8-32 screws provided.

GP I :ENERAL RODUCT NFORMATION

This fixture is intended to be installed utilizing NEC

compliant junction boxes.

This product is suitable for damp locations.

This product can be dimmed with a low-voltage electronic

dimmer.

MOUNTING

PLATE

FIXTURE

SCREW

1 1

ALLEN

WRENCH

#8-32 SCREW

Verify that the mounting plate is level before continuing.

Line an anchor tip with the center of an anchor hole,

and push the anchor into the wall up to the threads.

Screw the anchor in the rest of the way with a Phillips-

head screwdriver.

Repeat for the other anchor hole.

ANCHOR

4-Light and 5-Light Bath

PAGE 1
Installation Instructions for 4-Light and 5-Light Bath GENERAL PRODUCT INFORMATION: This fixture is intended to be installed utilizing NEC compliant junction boxes. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. This product is suitable for damp locations. This product can be dimmed with a low-voltage electronic dimmer.
PAGE 2
1D 1C ANCHOR 11 ANCHOR 6 4 WASHER SCREW 5 8 Slide a #8 screw through a washer, and screw it into an anchor to secure the fixture base to the wall. Repeat for the other anchor. 1B 4 Connect the mounting plate ground wire to a suitable ground in accordance with local electrical codes. 5 Connect the black fixture wire to the hot power line wire with a wire nut. 6 Connect the white fixture wire to the neutral power line wire with a wire nut.