Installation Sheet

Installation Instructions for

920SPHRC

Install the Fixture

Attach the mounting plate to the electrical box using

the two #8-32 screws provided.

Sphere Flush Mount ( )LED

With the Allen wrench provided, back out (do not fully

remove) the set screw at the base of the fixture and

remove the mounting plate.

ALLEN WRENCH

SET SCREW

MOUNTING

PLATE

MOUNTING

PLATE

SCREW

1.0

700FMSPH

GENERAL PRODUCT INFORMATION:

These fixtures are intended to be installed

utilizing NEC compliant junction boxes.

This product is suitable for damp locations.

This product may be dimmed with a low-voltage electronic

dimmer.

This instruction shows a typical installation.

CEILING COLLECTION

CAUTION RISK OF FIRE-

This product must be installed in accordance with the applicable

installation code by a person familiar with the construction and

operation of the product and the hazards involved.

Use minimum 90°c supply conductors.

PAGE 1
Installation Instructions for 920SPHRC Sphere Flush Mount (LED) 700FMSPH CEILING COLLECTION GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. This product may be dimmed with a low-voltage electronic dimmer. This instruction shows a typical installation.
PAGE 2
1C 1E FIXTURE BASE 9 SHADE SET SCREW 3 ALLEN WRENCH Screw the shade securely into the fixture base. 1D 7 Properly place all wires and wire nut connections into 4 the electrical box. 8 Hook the fixture to the mounting plate and swing the 5 bottom of the fixture toward the plate until it is flush with the wall. 6 9 Tighten the set screw at the side of the fixture.