Installation Sheet

2
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, 60077IL
847.410.4400
www.techlighting.com
© 2017 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company
1C
5
6
Position one piece of small glass over the fixture and
align with the threaded holes in the fixture.
Use two of the provided thumb screws to secure the
outer end of the glass in place.
4
5
6
4
7
Install the Glass Shades
2A
1
Connect the ground wire to a suitable ground in
accordance with local electrical codes.
Connect the white driver wire to the neutral power line
with a wire nut.
Connect the black driver wire to the hot power line with
a wire nut.
Use the purple and grey wires for a 0-10V dimming
application.
Properly place the driver, all wires, and wire nut
connections into the backplate and secure the fixture to
the mounting plate by reinstalling the two fixture
screws (reversal of step 1A).
2
2A
Overlap a large glass over the small glass installed in
step 2A and align the holes with the ones in small glass
and the fixture body.
Use two of the provided thumb screws to secure the
large glass and the small glass to the fixture body.
2A
3
4
2B
Slide the second small glass under the large glass and
align the holes with the fixture body.
Use two of the provided thumb screws to secure the
large glass and the small glass to the fixture body.
Install the second large glass as done in step 2B and
secure with remaining four thumb screws.
2A
5
6
2C
7
DRIVER
SMALL
GLASS
LARGE
GLASS
THUMB
SCREW
THUMB
SCREW
THUMB
SCREW
SMALL
GLASS
SMALL
GLASS
LARGE
GLASS
7
8
NOTE: The purple and gray wires are only used
for 0-10v dimming. For all other applications, do
not use the purple and grey wires.