Installation Sheet

1D
2
1C
Connect the backplate wire to a suitable ground in
accordance with local electrical codes.
Connect the white wire to the neutral power line.
Connect the black wire to the hot power line.
3
4
5
3
4
5
Hook the top of the fixture onto the backplate and place
the fixture flush against the wall.
Tighten the screw at the bottom of the fixture.
6
7
6
7
2B
2A
1
2
Screw the thumb screw into the back of the fixture
through the hole in the back of the glass shade.
3
NOTE: Do not over tighten the thumb screw. Over-
tightening may break the glass and cause injury.
Line up the slot in the back side of the glass shade with
the guide channel on the fixture.
Slide the glass shade all the way to the stop. If installing
the fixture so the glass points downward, hold the glass
in place with one hand until step 6 is complete.
2
1
Install the Shade
7400 Linder Ave, Skokie, IL 60077
847.410.4400
www.techlighting.com
© 2015 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company