Installation Guide

2
TAB
TAB
#8-32 SCREW
Make sure the two tabs on the mounting plate are
positioned at the top and bottom of the plate for
vertical mounting; at the left and right for horizontal
mounting.
Line up two mounting plate slots with the two electrical
box holes.
Level the mounting plate and secure it to the electrical
box with the two #8-32 screws provided.
MOUNTING PLATE
1C
1D
Ground the fixture in accordance with local electrical
codes.
Connect the two white fixture wires to the neutral
power line wire with a wire nut.
Connect the two black fixture wires to the hot power
line wire with a wire nut.
1E
MOUNTING
PLATE TOP TAB
TOP OF THE FIXTURE BASE
Place all wires and wire nut connections properly inside
the electrical box.
Hook the top of the fixture base over the mounting
plate top tab.
1F
Line up the fixture on the wall and then secure it to the
mounting plate by tightening the set screw at the base
of the fixture.
SET SCREW
ALLEN WRENCH
3
4
5
3
4
5
3
4
6
7
8
6
7
8
9
10
9
11
11