Installation Sheet

1.0

Installation Instructions for

Fett Wall

700WSFET-

920WSFETT

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing compliant junction boxes.NEC

This product is suitable for damp locations.

Incandescent version may be dimmed with a standard

incandescent dimmer.

LED version may be dimmed with a LED or TRIAC dimmer.

Consult lamp manufacturer for additional information.

WCALL OLLECTION

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Install the Fixture

Remove the fixture screws located on both sides of the

fixture base with the provided Allen wrench.

Remove the mounting plate from the fixture base.

MOUNTING

PLATE

FIXTURE SCREW

ALLEN WRENCH

ELECTRICAL BOX

Install the mounting plate onto the electrical box with

the two #8-32 screws provided.

#8-32 SCREW

PAGE 1
920WSFETT Installation Instructions for Fett Wall 700WSFET- 1.0 W ALL C OLLECTION GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. Incandescent version may be dimmed with a standard incandescent dimmer.
PAGE 2
Install the Lamp 1C 2A 6 4 C AUTION: To reduce the risk of a burn or electric shock during re-lamping, disconnect the power to the fixture. 5 Refer to fixture marking for lamp information. 4 Connect the mounting plate ground wire to a suitable ground in accordance with local electrical codes. 5 Connect the black fixture wire to the hot power line wire with a wire nut. 6 Connect the white fixture wire to the neutral power line wire with a wire nut.