Installation Guide

2
Install the Lamp
2A
1
LAMP
SOCKET
2B
SLOT
CLIP
HANGER BAR
Carefully slide the shade into the slot on the lower arm
while sliding the hanger bar onto the clips.
To secure the shade, attach the upper arm by tightening
the Allen-head screw.
2
3
Install the Fabric Shade
Install the Glass Shade
2C
SLOT
SCREW
SCREW
2
2
3
ALLEN
WRENCH
ALLEN WRENCH
6
1
CAUTION: To reduce the risk of a burn or electric
shock during relamping, disconnect the power to
the fixture.
Push the lamp base completely into the socket.
To install a fabric shade, continue to section 2B.
To install a glass shade, continue to section 2C.
Use MAX 120 Volt, 60 Watt Type T4,
G9 Base Bi-Pin Halogen Lamp.
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
847.410.4400
www.techlighting.com
© 2008 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company
Remove the screw and washer from the upper arm.
Slide the screw with washer through the hole in the
shade and screw it back into the upper arm.
Slightly loosen the thumbscrew in the lower arm.
Carefully slide the shade into the slot on the lower arm.
Tighten the Allen-head screw.
Reaching in from the bottom, push the shade support
plate against the shade and tighten the thumbscrew.
2
3
4
5
UPPER ARM
3
LOWER ARM
7
4
5
6
7