Installation Guide

2
TAB
TAB
#8-32 SCREW
Mount the Sconce to the Electrical Box
Make sure the two tabs on the mounting plate are
positioned at the top and bottom of the plate.
Line up two mounting plate slots with the two electrical
box holes.
Level the mounting plate vertically and secure it to the
electrical box with the two #8-32 screws provided.
MOUNTING PLATE
2B
Connect the green ground wire terminal ring to the
mounting plate with provided screw. Make sure that the
mounting plate is grounded in accordance with local
electrical codes.
Connect the black transformer wire to the hot power
line wire with a wire nut.
Connect the white transformer wire to the neutral
power line wire with a wire nut.
2C
MOUNTING PLATE
TOP TAB
TOP OF THE
SCONCE BASE
Place the transformer and all wires properly inside the
electrical box.
Hook the top of the sconce base over the mounting
plate top tab.
2D
SET SCREW
ALLEN WRENCH
Line up the sconce on the wall and then secure the
sconce to the mounting plate by tightening the set
screw at the base of the sconce.
2A
1
2
3
4
5
6
7
8
4
5
6
1
1
2
3
7
8
9
9